|
Division of Ron Bank Associates
|
|
ZURN Corrosive Waste Pipe and Fittings Mechanical Joint or Fusion!
The ZURN Corrosive Waste Drainage System combines both of the most popular joining systems -- Mechanical Joint and Fusion Joint. If your choice of joining the pipe and fittings is mechanical joint, only a low cost grooving tool is required. If your choice is fusion joint, a fusion joint machine is available. The single fitting type for both fusion and mechanical joint systems reduces the number of different parts therefore eliminating the need for dual inventories and ultimately reducing installation costs. All pipe and fittings meet applicable ASTM standards and are approved by NSF.
When absolutely nothing but a fusion joint connection is acceptable, the ZURN
Fusion Lock(tm) joint system is today's best choice in fusion technology!
The ZURN Fusion Lock Machine (shown at right) automatically senses the
connection size(s) and job site temperature and delivers the correct power
required to create perfect fusion joints, even with simultaneous multiple joint
setups! (Up to the specified maximum, see installation instructions for
details.)
To explore additional information on other typical Zurn Corrosive Waste
Piping Products including specification sheets, product information etc. or to
find the Zurn factory representative in your area, use the link below to go
directly to the ZURN Corrosive Waste Products website!
|
|
|